Basic configuration and Installation of FXS VoIP Gateway
How to install and configure FXS/FXO VoIP Gateway ?
•
Connect LAN Cable to NMG WAN port and Network Switch Ethernet port.• Connect PC/Laptop Ethernet Port to NMG LAN1.
• Go to Network setting in PC and select DHCP in IPV4 Network Address.
• NMG DHCP Server will allocate IP for PC.
• If DHCP server failed allocate IP address for PC, configure manually network IP address in network setting > Eth port > IPV4 [IP address for PC 10.91.8.11 Subnet 255.255.255.0]
• Open Google Chrome / Mozilla Firefox to Brows IP address 10.91.8.1 or http://10.91.8.1
Note:
- Recommended not to use only one router inbuilt
Ethernet port for NMG or PC connectivity.
- Check Ethernet cable using Loop Test or LED status
on device.
- Disable Firewall in PC during Back to Back
connectivity.
- Double check IP address in PC.
- Before allocation of IP address in NMG device make sure same IP address is not assigned to any other device or system.
Note: